 Thread Rolling Planetary Dies
Material symbol of dies
Suitable for the following use
L
Suitable for taper threads and extremely short threads. Has excellent durability against chipping, etc.
M
Most common, excellent durability and suited for a wide range of materials from common steels to HRC30 hardened steels and stainless steels.
...
|
 MLT Multi Tap
The Multi Tap has an End Mill on the tip and a Side End Mill in the complete thread portion right after the chamfered thread cutting teeth. With these end mills and tapping threads, deformed molded holes can be accurately milled and tapped in one cycle of tool feeding. ・ Internal threads are precisely trimmed by the Side End Mill at the sametime with the tapping process. With no burrs and ...
|
 BL-TF Burrles Taflet
Appearance of burrs from the minor diameter of the internal thread can be prevented and the finished surface will be less rough.
Thread height can be uniformly trimmed.
Tightening torque of threads will be improved.
Careful selection of the hole diameter can prevent double crests which sometimes occur with forming taps.
|
 IT Taflet IT - TF - T
Suitable for tapping Low-and Medium-carbon steel and Stainless steel, Aluminum alloy, and general non-ferrous alloys which have relatively low machining loads.
http://www.tanoi-mfg.co.jp/us/only/ittf/index.html
|
 IT Taflet IT - TF - C
Suitable for tapping High-carbon steel, Structural alloy steel, Modulated steel and Stainless steels which have relatively high machining loads.
|
 IT Taflet For Miniature Threads IT - TF - T
Suitable for tapping Low-and Medium-carbon steel and Stainless steel, Aluminum alloy, and general non-ferrous alloys which have relatively low machining loads.
|
 IT Taflet For Miniature Threads IT - TF - C
Suitable for tapping High-carbon steel, Structural alloy steel, Modulated steel and Stainless steels which have relatively high machining loads.
|
 Steamless Taflet (SL-TF)
・
Internal threads are milled simultaneously with the tapping process. This avoids any offset in the threads, improving the concentricity of the internal diameter.
・
The seam portions are removed, so burrs are prevented.
・
Since there ...
|
 Steamless Taflet Long Shank (LT-SL-TF)
Internal threads are milled simultaneously with the tapping process. This avoids any offset in the threads, improving the concentricity of the internal diameter.
The seam portions are removed, so burrs are prevented.
Since there is no seam in the minor diameter of the internal thread, no plating liquid remains in the seam and rust is prevented.
Compa ...
|
 Burrless TAFLET
・
Appearance of burrs from the minor diameter of the internal thread can be prevented and the finished surface will be less rough.
・
Thread height can be uniformly trimmed.
・
Tightening torque of threads will be improved.
...
|
