 AC/ COLLETS & ARBORS - ＡＣ Tork-Lok Collets & Arbors Short Series
Short Series is suitable for workpieces with a small grip allowance. Also, this is suited to reducing overhang of NC lathes or to performing a little heavy-duty cutting on workpieces that require a restrictor and would be susceptible to torsion during operations if standard drawbars were used.
|
 AC-HL Hand-Lok Collets & Arbors
Standard Series and Short Series
Best Suited For Small-Lot ID Chucking
Hand-Lock Collets & Arbors employs a manual collet attachment incorporating a cam mechanism to allow easy use of the AC arbors that provide excellent performance in the inner diameter chucking.
For lathe, milling, drilling, index table and etc.
|
 AC/ COLLETS & ARBORS - ＡＣ Tork-Lok Collets & Arbors Standard Series
Standard Series is designed to cover a wide range of inner diameters from 12.7 mm to 113.4 mm. Compared with the Short Series drawbar type, this offers larger bending tolerances and higher resistance against frequent idle operations, so it is recommended for use on short workpieces requiring a restrictor (for collet opening).
|
 PC MULTI-SIZE COLLET / Power Chucks
The disk-spring power pack enables the chuck to powerfully grip workpieces.
This is suitable for continuous operations and secondary machining, allowing full utilization of the spindle hole very accurately.
Also, economical power units and peripheral devices can be used.
|
 UNIVERSAL BALL-LOK CHUCKS (UBL Power Chuck) - UBL Centralizing Type
This is a general type chuck with the chucking portion centered, and with the stopper face aligned to edge face. This type of chuck securely clamps even black-skin cast/forged parts with draft (up to 20°) to ensure consistent dimensional accuracy in the axial direction even during heavy-duty cutting. Two-jaw or three-jaw structure is available. The chuck can be easily changed for either OD ...
|
 UNIVERSAL BALL-LOK CHUCKS (UBL Power Chuck) - UBL Compensating Type
The compensating type is designed to allow the jaws to grip a workpiece at equal forces along the workpiece perimeter with respect to both center/boss holes. Two-jaw or three-jaw structure is available. All parts except the actuator are the same with those of the Centralizing type. The compensating-type UBL Chuck offers a wide range of chucking, depending on boss and center holes. Also, this ty ...
|
 Fixtures
Standard Series and Short Series.
Easy lever operationsï¼
Tork-Lok Fixture is used with the “Tork-Lok” Drawbar-type arbor. This fixture gives great holding power to the arbor through easy lever operations. It can be used for a broad range of machining applications such as milling, drilling, and boring, allowing facility and maintenance costs to be s ...
|
 Between Centers Model Standard Series
Tork-Lok Between-Center Arbor is designed to hold the workpiece through the hole-referenced ID chucking and then to be supported between centers of machine tool for turning and grinding operations.
|
 Between Centers Model Short Series
Tork-Lok Between-Center Arbor is designed to hold the workpiece through the hole-referenced ID chucking and then to be supported between centers of machine tool for turning and grinding operations.
|
 PA PIN-ARBOR Chucks (I.D. Chucking) Standard Series
PA - 25・35 PA - 55・75
Securely d ...
|
